41601 Feature Control KEY: Too many devices detected. Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Thermoflex Think_Motion_Controller The firmware has detected too many devices connected to the dongle port. Try removing one or more devices from the dongle bus to reduce the total number of dongles on the bus. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Either the dongle bus has too many dongle devices attached, or is malfunctioning. A maximum of 10 devices on a single one-wire-bus are supported by the firmware. 08-JAN-2001 Automated conversion to new FW1 error template. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:35 2008 PST